Juiced Bikes Scrambler HT and Scrambler FS: parts and specs

This page lists the common replacement parts and service sizes for the Juiced Scrambler, sold from 2026 as the Scrambler HT (hardtail) and Scrambler FS (full suspension). Specs are for the stock bikes as sold; check your own bike before you buy. The Scrambler user manual, on Juiced's help center, covers both versions and gives more bolt sizes and torque values than most, which makes this bike easier to look after at home.

Parts list

• Tire: 20 x 4.5 inch. The range figures are for 30 PSI; for everyday riding, inflate to the range on your tire sidewall.
• Disc brake pads: replace pads when wear passes 2.0 mm, or when total pad thickness is under 3.0 mm. The pad model isn't named, so ask Juiced support for the right one.
• Brake rotor: rotor bolts take a T25 Torx at 5 to 8 Nm. The rotor size isn't stated.
• Disc brake caliper: hydraulic disc brakes front and rear. Caliper mount bolts take a 5 mm hex at 10 Nm. Use only mineral oil, and only the oil Juiced sells, never DOT fluid.
• Brake lever: lever clamp bolt takes a 4 mm hex at 4 to 5 Nm.
• Rear derailleur: mount bolt takes a 5 mm hex at 8 to 10 Nm.
• Throttle: thumb throttle on the right bar, clamp bolt 3 mm hex at 1 to 2 Nm. It works only with pedal assist above 0.
• E-bike display: Juiced cockpit display with power and plus and minus buttons, mount screw 2 mm hex at 1 Nm.
• E-bike charger: D-POWER DPLC295V55. Plug it into the port on the side of the battery, on or off the bike. The light is red while charging and green when done. Keep the rubber plug in the port when not charging.
• E-bike battery: 52V lithium-ion, 19.2Ah on the range-tested bike, keyed lock and an on and off switch. Store it at about 60 percent and check it every 3 months.
• E-bike lights: front and rear lights with turn signals and hazards. Front light mount 5 mm hex, rear light 3 mm hex, both 4 to 5 Nm.
• Pedals: 6 mm hex at 35 Nm, marked R and L.

Tools for common jobs

• Hex keys: the bike uses 2, 3, 4, 5, 6 and 8 mm hex bolts, from the display screw to the crank bolt.
• Torx keys: a T25 Torx for the brake rotor bolts.
• Torque wrench: nearly every bolt has a torque value, for example 35 Nm for the rear axle and 10 Nm for the caliper bolts.
• Axle nut wrench: the rear axle nut takes a 21 mm wrench, at 35 Nm.
• Tire levers: changing the 20 x 4.5 tire or tube.
• Floor pump with gauge: checking pressure monthly.
• Brake pad spreader: resetting the hydraulic pistons before fitting new pads.
• Brake bleed kit: bleeding the brakes with the mineral oil Juiced sells, never DOT fluid.
• Chain checker: checking chain wear.
• Chain lube: lubing the chain monthly.

Have a shop check the brakes and bolt torque after the first 100 miles or 5 full charges, and give the bike a full service at least once a year.

Where to buy

• Juiced's help center has the manual for each model. For parts Juiced doesn't list online, contact Juiced support with your model and serial number.
• Independent sellers are listed on our parts suppliers page.
• A local shop can order and fit parts: find a shop.

Common repairs

• Juiced Bikes troubleshooting
• Scrambler charging light always red
• Replace disc brake pads, bleed hydraulic disc brakes and check bolts and torque
• Fix a flat on a rear hub motor wheel

Sources

• Scrambler user manual, cdn.shopify.com
• help center, juicedbikes.com

Stuck after these checks? Find a shop near you.