Added sources and updated by the Pedalwise team

The board stutters, the motor inside the tire makes an odd noise, or the lightbar blinks a code you count as 6, or 11 on a GT. Onewheel says these point to a motor cable that is not communicating properly (Onewheel blink codes, error 6 or 11 on GT and GT S-Series, error 6 on Pint). This page covers the GT, GT S-Series, Pint, Pint X and XR, the models Onewheel gives motor cable guidance for. The short answer: power cycle, then the motor cable connection, then Onewheel service.

Most likely cause

The motor cable carries signals between the hub motor and the controller module. When it is not communicating properly the board can stutter, and the error can show as code 6, or 6 or 11 on the GT family. Onewheel's articles have riders check that cable's connection at the controller module for obstructions and damage (GT article, Pint article).

Other causes to rule out

• Cables back in the wrong place after the footpad was removed. Onewheel's XR article shows the footpad cable and motor cable in neighbouring slots and says to check each is in the right one (XR article).
• A motor that was stalled while engaged, for example pushed into a wall or stuck on a curb. Onewheel says a power cycle should clear that case (XR article).
• Debris in the fender, which Onewheel lists as a simple cause of unusual noises (FAQ).

How to confirm

1. If the code appears while riding, Onewheel says the board gives extreme pushback: lean back to slow down, stop and get off (GT power and status). Don't ride on until it is sorted.
2. Power off, set the board on the ground in the riding position and power on. Count the blinks again (Onewheel blink codes).
3. With the board off, check the fender for debris.
4. For a noise, Onewheel asks for a 10 to 15 second video with fenders and accessories removed, sent to support with the serial number (FAQ).
5. Send diagnostics from the app and open a support ticket, since Onewheel says diagnostics alone get no reply (FAQ).

Fix options

Power cycle (easy)

Onewheel says turning the board off and on should clear codes 3, 4, 6, 15 and 16 when a one time event caused them (Onewheel blink codes).

Reseat the motor cable (moderate, Onewheel's own steps only)

For a code that keeps returning, Onewheel's articles walk you through removing the front footpad, unplugging the motor cable at the controller module by its locking collar, checking both sides for obstructions and damage, and reconnecting with the board off. Use the article for your model: GT and GT S-Series or Pint. Onewheel says not to pull until the collar is loose, to check you are twisting the right piece if you feel resistance, and to contact them if you are uncomfortable.

Onewheel factory service (pro)

If the board still stutters or won't engage, Onewheel says it can start bringing the board in. Motor and controller work is done by Onewheel's factory service. Don't open the motor or controller yourself.

Parts

• No rider replaceable part. Onewheel factory service handles motor and controller repairs.

When to get a pro

Any code 6 or 11 that returns after a power cycle and a careful reseat, a damaged motor cable or connector, or a grinding noise. See Onewheel troubleshooting and when to call a pro.

Sources

• Onewheel blink codes, support.onewheel.com
• error 6 or 11 on GT and GT S-Series, support.onewheel.com
• error 6 on Pint, support.onewheel.com
• XR article, support.onewheel.com
• FAQ, onewheel.com
• GT power and status, onewheel.com
• factory service, onewheel.com

Stuck after these checks? Find a shop near you, or if you're in Austin, book a Pedalwise tech.